hi!!!

i have some exclusive (love that word!!) info on how to make a volume pedal. the parts are as follows:

4-mono 1/4 inch jacks
1- dual engaged potentiometer (tell you more on this later)
other
press 'n' peel blue
blank pcd board with copper on top
wire
solder
and most importantly soldering iron.
if you visit http://www.tonepad.com they will tell you what to do!
now all you have to do is copy the image bellow and paste it to a progran like paint or word and print out 2 copys. then get your press 'n' peel blue and cut to roughly the right size to cover the picture with some left over. then solotape that piece of of p'n'p over the image with the dull side up (adhesive side) and go to a photo copier, put the the copy without the the p'n'p on in the reader section and the one with the p'n'p on in the paper tray, press copy and it sould have copied onto the pnp.now roughly cut out the pcb and sand down the edges and polish the copper. now you are ready to iron the image onto the the pcb. put the pnp dull side down onto the pcb and iron for 10 mins pushing down hard for 30 secs and circullary for 1 min. let it cool and then peel of the pnp. now you must etch it which is too detailed so go visit http://www.tonepad.com. after etching go and drill the board and solder it and put in a case!
done
this is the picture
oh no slight problem you will have to email me for the pic my emails callum@woollams.co.uk just say some thing like volume pedal picture and i will email the pic