I have a router, band saw, radial arm saw, compund miter saw, joiner, ad infinitum. I do quite a bit of woodworking and quite a bit of guitar playing, and finally they intersect. I was going to buy a neck that has a fourteen inch extension and then add mahogany wings to the side of it. I had to make some compromises to the design to make it easier for the routing (the bridge routing I'm still having done by a pro). I am worried about the finish, especially since the neck is going to attached when it comes time to paint it. I would like to get the specs and dimensions for that v, I'm not sure about the lengths.

~13noon