Ok. RRRR i just typed a long involved post that got screwed up when i hit reply in my coil tap madness thread. So to summarize it...

A)I have the pups and a push/pull volume

B) From what i understand from the dimarzio site, this is how to wire everything. Solder red wire (hot) and green (ground to 3-way selector)

C)Assume this is the posts of the push/pull.
1_2
3_4
5_6

1- Solder bare wires from 1 to 2 then to ground
3- Solder 2 remaining wires (white and black) (Neck pickup)
4- Solder 3 remaing wires (Bridge pickup)

D)Would I be right in assuming that when the push/pull is pulled, that when in up postion, the switch selects single coil neck. When in center postion it selects single coil neck and single coil bridge, etc...

Help is greatly appreciated, and thanks for all your patience im an electronics noob.