Well the pickup came yesterday (yay early arrival) but there was a slight dilemma. After gettin the pup ready to put in I noticed there was no diagram for my guitar setup. I read through Pony's thread and thought I knew what I was doing until the cable comming from the new pup had wires pre-soldered together. So I went to EMG's site and saw that most of their pups don't have the coil split capabilities, and that if I wired it in with my 5 way switch that position 2 would be a dead spot and could ruin my speakers if I switched to it. So I called EMG for help (I figured I would have to re-wire) and they were closed for the day so I left a message with the tech. He called a few minutes ago and said the website was right, but since I have one of the HZ models (HZ-4), they have the coil splitting capabilities and can be wired in no problem that I can just de-solder the wires, and that the quick connect cable is not made by them but another company and that they pre-solder the wires for some reason (I forget what he said.) So I'm off to solder on the new pup.