I'm in the process of building a guitar from warmoth (read "opinion's on custom guitar" in the gear section) and want to use lace sensor hot gold pup's. a 6k for the neck and middle and a 13.2k for the bridge. I want to wire them with 1 250k volume knob for the neck and middle, and 1 250k volume knob for the bridge and 1 250k master tone knob. could anyone point me in the right direction of a wiring schematic for this type setup. all I can find is for 1 vol. and 2 tone. I know I could probably figure it out from that, but I want to be 100% sure before I start soldering wires to stuff. Also, should I line the cavity with copper shielding tape? Thanks for any help!