Yes describing your problem would be helpful. I just adjusted mine. It's not as difficult as you might think. The problem I had is that the action was a lot higher at the bridge end of the neck than at the nut end. So basically what was hoping to do was to tilt my neck back a little. To accomplish this, this is what I did :

* remove strings
* unbolt neck off guitar
* put a 1" wide strip of 60 grit sandpaper all they way at the back of the neck saddle of the body.
* put neck back on
* put strings back on returned
* Adjust the height of the licensed Floyd Rose trem just a bit

I know that when i was facing this, it seemed really involved, but actually i found it wasn't all that bad.